PR009
1
5
1
1
screw holes not in right place
I put the PR009 on the palm router. I was using a porter cable centering jig. I didn't notice that there was a little offset of the bit when I put it in. I found that the position of the bit changed hen I rotated the router. When I measured the holes in the plate, I found them to be 3 inches and 2 3/4 inches apart. But two were 9/16 inches in from the outer edge of the guide and two were 11/16 inches from the outer edge of the guide. These measurements shoud all be the saame. This is inexcusable. The numbers on the guide were 2 609 100 496, pm- gf30and it had made in Malaysia on it.
March 30, 2012